The Voltcraft 103552 17.8cm/3.9mm/45 is a Rigid Camera Probe for use with Endoscopes BS-500 and bfor visual fault tracing or inspection with dead-voltage systems and equipment.
The four LEDs built into the camera head enable shooting in total darkness, with brightness controlled via the connected endoscope The waterproof camera neck and camera head are ideally suited for dead-voltage fluids (not acids or alkaline solutions).
The probe is supplied with a 45° tube allowing you to view unreachable areas The probe sleeve can be rotated by 360° for easy inspection of engine blocks or other narrow openings The power required by the probe is supplied via the connected endoscope.
What's in the Box?
Camera
Protective cap
Carrying case
Spiral extension cable
45 degree mirror tube
Handle
Cleaning kit
Operating instructions
- 90° screw-on, side-view optics, rotatable
- 39mm probe diameter
- Compatible with BS-500, BS-1000T
- Ergonomic handle
- Convenient spiral cord
- Watertight: (IP67)
- Resistant to motor and gear oils
- Supplied with a Rigid Probe Length of 17.8cm
- Supplied with a Probe Width of 3.9mm
- Manufacturer's part: Voltcraft 103552
| Type |
Endoscope probe |
| Channels |
1 |
| Interface |
N/A |
